Troubleshooting - Dometic HIPRO CRUISE LINE N30GCL Instrucciones De Uso

HiPro
9

Troubleshooting

Fault
Not cooling
Not cooling, indicator
LED continuously flash-
ing
Poor cooling perfor-
mance
EN
Possible cause
Power plug not plugged in
No voltage at socket
Electronics or sensors defective
Auto-defrost active (see chapter
"Defrosting" on page 13)
Minibar recently switched on
Cooling unit defective
Minibar automatically switched off by
temperature sensor
Cooling unit blocked
Cooling unit not water-tight
Heating element defective
Error during self-test
Cooling unit not sufficiently ventilated Provide sufficient ventila-
Minibar exposed to direct sunlight
Door of minibar not closed with a
tight seal
Minibar recently filled
Troubleshooting
Solution
Insert power plug into
socket
Check circuit breaker
Contact service agent.
Service agent: Install new
electronics or sensor
No action required
Check cooling again after
5 to 6 hours
Contact service agent.
Service agent: Replace
minibar
Provide sufficient ventila-
tion, see Installation
Manual
Contact service agent
tion, see Installation
Manual
Take minibar out of direct
sunlight
Check distances, see
Installation Manual
Contact service agent.
Service agent: Replace
door seal
Check cooling again after
5 to 6 hours
15