Best WPD28I Manual De Instalación página 10

13. OPERATION
The hood is operated using the 3 controls located beneath the front edge of the hood.
A
HC0014
A) Light switch
B) Blower ON/OFF switch
C) Blower speed control
A) LIGHT SWITCH
The light switch turns the halogen lights ON and OFF.
Use GU10, 50 W, 120 V shielded halogen lamps (included).
B) BLOWER ON/OFF SWITCH
The blower ON/OFF switch turns the blower ON to the speed pre-set by the speed control. The blower must be turned
ON and OFF using this switch.
C) BLOWER SPEED CONTROL
Use the blower speed control to increase or decrease cooktop ventilation. Rotate the control to the left to increase the
blower speed—to the right to decrease the blower speed.
HEAT SENTRY™
This unit is equipped with a Heat Sentry thermostat. This thermostat is a device that will turn on or speed up the blower
if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting – it turns the blower up to HIGH speed.
The Heat Sentry can start the blower during a range top fire or other excessive heat situations
even if the hood is turned off. If this situation occurs, it is impossible to turn the blower OFF with
blower switch. If you must stop the blower, do it from the main electrical panel.
When the temperature level drops to normal, the blower will return to its original setting.
Test all hood switches.
U
SING HOOD WITH A COVERED GAS GRILLE
When opening the cover on your gas grille you may notice a reduction in the capture of smoke and steam.
B
WARNING
!
- 10 -
C