Peavey Assisted Listening System Manual De Instrucciones página 10

POWERING THE RECEIVER
Install (2) AA batteries in BATTERY COMPARTMENT observing polarity.
To preserve battery life, always turn the Peavey Assisted Listening
Receiver off when it is not in use. When the sound becomes weak or
distorted, replace the batteries. The number of hours of operation for
batteries is as follows: carbon zinc type battery: 10-12; alkaline battery
(recommended): 17-20 hours.
USING THE PEAVEY ASSISTED LISTENING SYSTEMS EARPHONES
Plug the included earphones into the EARPHONE JACK (2) on top of the
receiver. The ear pads can be ordered separately. However, they can be
replaced and reused after being washed in a mild detergent, rinsed and
air dried.
OPERATING THE RECEIVER
While wearing your earphones, turn the receiver on by rotating the
OFF/ON/VOLUME WHEEL (3). The POWER ON INDICATOR (4) will
illuminate. (To turn the receiver off, rotate the OFF/ON/VOLUME WHEEL
(3) until it clicks, and the "Power On" indicator will go out.) Listen for your
program source, and adjust receiver volume to a comfortable listening
level.
Note: A slight buzzing may be heard if the receiver is used within six feet
of the transmitter. This is normal and does not affect performance. For
best performance, keep the receiver and the transmitter at least ten feet
apart.
ADJUSTING EARPHONE VOLUME
Listen for your program source, and adjust receiver volume to a
comfortable listening level.
Note: A slight buzzing may be heard if the receiver is used within six feet
of the transmitter. This is normal and does not affect performance.
TESTING RECEIVER RANGE
Wearing your receiver and earphones, walk around your seating area