Descargar Imprimir esta página

Sunbeam 9710 Manual De Instrucciones página 10

Ocultar thumbs Ver también para 9710:

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly
10. Perform Leak Test
WARNING
Perform all tests outdoors.
Extinguish all open flames.
NEVER leak test when smoking.
Do not use the fire table until all connections
have been leak tested and do not leak.
(I) Make 2-3 oz. of leak test solution (one part liquid dishwashing
detergent and three parts water).
(II) Apply several drops of solution where hose attaches to regulator.
(III) Apply several drops of solution where regulator connects to cylinder.
(IV) Make sure all fire table and light valves are OFF.
(V) Turn cylinder valve ON.
If bubbles appear at any connection, there is a leak.
(I) Turn cylinder valve OFF.
(II) If leak is at hose/regulator connection: tighten connection and
perform another leak test. If bubbles continue appearing, the hose
should be returned to the place of purchase.
(III) If leak is at regulator/cylinder valve connection: disconnect,
reconnect, and perform another leak test. If you continue to see bubbles
after several attempts, cylinder valve is defective and should be returned
to cylinder place of purchase.
If NO bubbles appear at any connection, the connections are secure.
NOTE: Whenever gas connections are loosened or removed, you must
perform a complete leak test.
11. Install Battery to Electronic Igniter
(I) Remove the rubber cap on the electronic igniter (A) by unscrewing
and slide battery (B) into the battery slot. Make sure the positive side of
the battery faces outwards. Screw the electronic igniter cap (A) over the
battery tightly.
• Do not store a spare LP-gas cylinder under or near this
appliance.
• Never fill the cylinder beyond 80 percent full.
• Place the dust cap on the cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on the
cylinder valve that is provided with the cylinder valve. Other
type of caps or plugs may result in leakage of propane.
CAUTION
Do not operate this fire table if Firebowl Pan and Flame Glass
are wet!
Page 10
10
Hose/Regulator Connection
Regulator/Cylinder Connection
11
A
B

Publicidad

loading