Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
4. Attach the Table Top (A) to the assembled side panels. Align the holes
in the Table Top (A) with the holes at the top of the assembled Side Panels
(C/D) and insert M8x16 Bolts through M8 Washer (EE) and through holes.
Tighten with Wrench B (GG). Align the holes in the control box with the
holes at the left side panel, insert M8x10 Bolt, tighten the Bolt.
DO NOT OVERTIGHTEN as you will need to adjust the holes to ensure
proper alignment.
Hardware Used:
DD
M8x16 Bolt
EE
Washer
HH
M8x10 Bolt
5. Pour the Flame Glass (H) around the burner.
6. Close the door. Fire table assembly is now complete. At the bottom of
legs, there are four adjustable screws. Consumer can adjust the screws
to an even height.
7. Put the Lid (J), then the Protective Cover (I) on the fire table when the
fire table is NOT in use or after use, when the fire table has cooled down
COMPLETELY. This will prevent water from accumulating in the Firebowl
Pan and to protect exterior surfaces.
Page 8
Note: The Control box
on the burner Assembly
x 4
should face towards
the D panel with a hole.
To ensure the control
box and the left side
x 4
panel align, adjust the
two screws to atteched
table top and control
box.
x 1
After completely
assembling the fire
table, please tighten
all the screws on the
fire table.
Yellow
7.5"
Light Blue
Blue
Good Flame
4
5
Yellow
7.5"
Light Blue
Blue
Good Flame
6
Yellow
Light Blue
Blue
Bad Flame
7
5 9
Li
Blu
Bad Flame
Publicidad
