Air Valve Connection - Seamax SUP20D PRO Manual De Usuario

Bomba de aire eléctrica

Ocultar thumbs

Contenido

Tabla de contenido

Seamax Portable12V SUP-20D Electric Air Pump for Inflatable SUP, Kite and Inflatable Boat

FAULT

The air pump

1. The power source is not

cannot be started

plugged properly.

normally.

2. The fuse in DC plug (7) is

burnt out.

3. Overheating or overload.

Slow or abnormal

1. Check whether the hose is

inflation.

blocked or cracked.

2. The joint between the

hose and air pump or

inflatable product is not

installed properly.

3. Make sure the power

source meets the pump's

requirements 12V 15A

▪

This pump is suitable for the products with HR (Halkey-Roberts), Bravo or similar air valve. They are the most popular air

valves for the inflatable SUPs and paddle boards in the current market. This type of air valve has a center turning pin (HR

valve) or pushing pin (Bravo) control the air valve's Open / Close position. The universal valve adapter supplied with the

pump shall fit it.

▪

Please make sure the air valve is in its Close position when inflating the air chamber. Otherwise, some air may leak from

the valve when the air hose is being disconnected. Our air pump comes with universal HR valve adaptor with 3 different

thickness Silicon Rubber O-Rings (3mm/5mm/6mm ). The 6mm O-ring is per-installed on the air hose valve adaptor. It

should have one to fit your air valve best and air tight.

▪

If you cannot use our valve adapter for your inflatable product, you may have to cut the hose to install yours from the

original manual pump. You can use the electric tape to ensure the diameter fit and tight. You can also contact with

Seamax Marine to apply a set of Free Air Hose for this modification.

INSPECTION

1. Make sure the connect to the 12V DC socket.

2. Change the fuse.

3. Take off the Sand Cap from the pump intake or outtake. Cool

the motor and restart it. Turn on the pump in the air to force it

fast cool down.

1. Change the hose or make it unblocked, and check whether the

hose is cracked.

2. Reinstall the hose or valve adaptor, put the right size O ring

3. If the problem cannot be solved, please contact with the

manufacturer or its service agent or the similar authorized

personnel.

4. Do NOT use compact AC to DC wall convertors to power the

pump. Connect the pump car charger adapter directly to a car's

charger socket. Or use a well charged minimum 12V 7AH external

lead acid battery with the optional 12V battery connector.