Publicidad
Idiomas disponibles
Idiomas disponibles
Attachment
Hole
Picture 1.
Driver's Side Attachment
Mount
hitch
bracket to
rear face of
Tow Hook
Tighten 7/16"-Gr.5 Carriage Bolt with torque wrench to 50 Lb.-Ft. (68 N*M), Tighten 5/8"-Gr.5 Carriage Bolt with torque wrench to 150 Lb.- Ft. (203 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
© 2012 Cequent Performance Products
Installation Instructions
Mitsubishi Lancer
All single exhaust models inc. GT
Another Fine Cequent Performance Products hitch
Passenger's Side Forward
Attachment
Vehicle Forward
Picture 2.
Tighten 8mm bolt to 25 Lb.-Ft. (37 N*M)
Insert Bolt Leader up
through attachment
hole and back down
through enlarged access
hole
Access Hole,
enlarge to
allow block
to fit through
Passenger's Side RearAttachment
Picture 3.
Sheet 2 of 6
60302N
Part Numbers:
60302, 24885, 77273
INSTALLED HITCH
All you see is the
receiver tube!
Remove this 8mm bolt
5-29-12
Rev. A
Publicidad
