Publicidad
Idiomas disponibles
Idiomas disponibles
[Installation of Wiring harness]
Installation
1. Disconnect the battery (–) lead
wire. (Refer to the GSX-R1000/
A service manual)
Be careful not to disconnect
the battery (-) lead wire at
least 5 seconds after ignition
switch is turned to OFF. If the
battery (-) lead wire is discon-
nected within 5 seconds after
ignition switch is turned to
OFF, there is a possibility of
an unusual valve position
being written in ECM and
causing an error of throttle
valve operation.
2. Replace the standard ECM with
the ECM 5 included in the set.
(Refer to the GSX-R1000/A ser-
vice manual)
NOTE: When
3. Remove the fuel tank. (Refer to
the GSX-R1000/A service man-
ual)
NOTICE
the
ECM
replaced, previous setup
of the TC mode and S-
DMS mode will be reset.
Therefore, set the cus-
tomer's TC mode and S-
DMS mode again at the
Suzuki dealer.
is
GENUINE SUZUKI ACCESSORIES
3/12
Battery (-) lead wire
ECM
Fuel tank
Publicidad
