Cleaning And Maintenance - Rowenta Silence Force Extreme Multi-Cyclonic RO82 Serie Manual Del Usuario

CLEANING AND MAINTENANCE

The air we breathe contains particles that can be
allergenic: larva and dust mite feces, mold, pollen,
smoke and animal waste (hair, skin, saliva, urine),
etc.
The finest particles can penetrate deep inside the
respiratory system or can cause inflammation and
affect the entire respiratory system.
(H)EPA ([High] Efficiency Particulate Air Filter)
filters retain the finest particles.
Thanks to the (H)EPA filter, the air released into the
room is cleaner than the air suctioned.
IMPORTANT: always switch off and unplug
your vacuum cleaner before cleaning or
servicing. Check and clean your vacuum
cleaner and the different filters regularly.
IMPORTANT: do not operate your vacuum
cleaner without the filtration system fitted
(foam, microfilter and filter).
1 • Emptying the dust compartment (5)
After each use, empty the dust compartment as
follows:
Take the dust compartment by the handle and
remove it (fig.15).
Separate the fine dust compartment (5b) from the
main compartment (5a) (Fig.16).
Empty the main compartment over a dustbin
(Fig.17) then empty the fine dust compartment
(5b) (Fig.18).
Clean the compartment seals using a cloth.
Reposition the fine dust compartment on the
main compartment (Fig.19) then put the dust
compartment back into place (fig.20).
IMPORTANT: do not use the vacuum cleaner
once the maximum level (6) is reached on the
dust compartment.
2 • Cleaning the black foam filter
(18a)
IMPORTANT: clean the black foam filter every
6 months or when the suction is no longer
satisfactory.
Press the cover release button (fig.21). Tip the
cover backwards (fig.22).
Remove the black foam filter (fig.23) then wash
and squeeze it (fig.24). Leave to dry for at least 12
hours before refitting.
* According to model: these systems are specific to certain
models or are accessories available as an option.
ATTENTION: let the black foam filter dry
completely and make sure it is completely
dry before placing it back in the appliance.
Reposition the black foam filter and close the
cover.
3 • Cleaning the microfilter (18b)
IMPORTANT: clean the microfilter every 6
months.
Press the cover release button (fig.21). Tip the
cover backwards (fig.22).
Remove the filtration cassette (18) then separate
the black foam filter (18a) from the microfilter
(18b) (fig.25).
Wash the microfilter (fig.26). Leave to dry for at
least 12 hours before refitting.
ATTENTION: allow the microfilter to dry
completely before refitting it onto the
appliance.
Reposition the black foam filter and close the
cover.
ATTENTION: your appliance is equipped
with a safety system (19) for detecting the
filtration cassette: the cover cannot be
closed if the filtration cassette is not fitted
(18a+18b).
IMPORTANT: if the appliance does not
perform as normal after cleaning the black
foam filter and microfilter on your vacuum
cleaner, clean the HEPA filter.
4 • Cleaning the HEPA filter (17)
Remove the accessory support (30) then place the
vacuum cleaner in the vertical position (Fig.27).
Open the HEPA filter hatch (Fig.28).
Remove the HEPA filter from its housing (fig.29).
Clean the HEPA filter by gently patting it over a
dustbin (fig. 30). Reposition it in its housing
(Fig.31).
Reposition the hatch until you hear a click
indicating that it is closed (Fig. 32).
IMPORTANT: replace the HEPA filter every 12
months. The HEPA filter (ref ZR9015) is
available from your dealer or in Approved
Service Centres.
5
EN