Publicidad
8 8
D
37S
BLACK 7/8" MACHINE SCREW
(1 used for the KNOB)
64K
F
D
15H
6S
9I
BROWN 7/16" LARGE HEAD SCREW
(1 used for the PIVOT HINGE)
Carefully stand your unit upright.
Insert the remaining PIVOT HINGE (15H) into a WASHER (9I) and into the lower SHELF/BOTTOM (D).
Insert the PIVOT HINGE, which is fastened to the DOOR (F), into the hole in the upper SHELF/BOTTOM (D). You will need to tilt
your DOOR slightly.
Now, tip the DOOR in and fasten the free HINGE to the DOOR. Use a BROWN 7/16" LARGE HEAD SCREW (6S).
NOTE: To make adjustments to the DOOR, loosen the SCREW in the HINGE, make needed adjustments, and tighten the SCREW.
NOTE: The hole for the KNOB is not drilled completely through. Finish drilling the hole for the KNOB using a 1/4" drill bit.
Fasten the KNOB (64K) to the DOOR (F). Use a BLACK 7/8" MACHINE SCREW (37S).
414031
www.sauder.com/services
Page 11
Publicidad
