Publicidad
Step
Step 27
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (XXXX) and lay it over the center of your unit.
Fasten it with a hammer and sixteen NAILS (1N).
Make equal margins along the outer edges of the LARGE
å
BACKS. Push on opposite corners of your unit if needed
to make it "square".
Fasten the remaining BACKS (YYYY and WWWW)
å
overlapping them to the CENTER BACK (XXXX) as shown
in the enlarged view. Fasten the BACKS to your unit using
twenty BLACK 9/16" LARGE HEAD SCREWS (1S) and the
NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELVES (P, S, and T).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
BLACK 9/16" LARGE HEAD SCREW
Overlap the BACKS.
www.sauder.com/services
1S
(20 used in this step)
YYYY
YYYY
XXXX
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
WWWW
XXXX
418653
1N
NAIL
(106 used in this step)
1S
1S
These holes must line up over
the SHELVES (P, S, and T).
1S
Page 33
Publicidad
