3.6 Drill holes
It is possible to provide drill holes for our thermostatic cabinets. On request, the drill
holes may be made by the Production Department for new orders of a Thermostatic
Cabinet. Alternatively, the customer may drill the holes on-site at a later date.
Please note: In both cases, drilled holes will void the guarantee on the accuracy
of the temperature´s stability! So long as the procedure is carried out correctly,
statutory rights will not be affected.
The dimensions and possible drill areas are described in the graphic and respective
tables below . In addition, the following should be taken in to consideration:
•
Maximum hole size available by our production team: Ø 30 mm
•
Wall thickness: 35 mm
•
Initially, each hole is drilled from the inside to the outside with a diameter
of approx . 3 mm . Then the hole can be drilled from the outside to the desired
diameter / size .
18
Thermostatschränke • Incubators • Etuves réfrigérées
Armarios termostaticos • Estufas reguladas por termóstato_7 09/2012