Connections To Be Made - Axxess AW-INCH1 Manual De Instalación

From the LD-BX-CH1 OR LD-BX-CH2 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 (sold separately), there will be an
accessory wire there to connect as well.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• If the vehicle is equipped with a factory amplifier, connect the Blue/
White wire to the amp turn on wire. This wire must be connected to
hear sound from the factory amplifier.
• Connect the Blue wire to the power antenna wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output .
AW-INCH1

Connections to be made

The following (3) wires are only for multimedia/navigation radios that
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included)
2
®
require these wires.
to retain steering wheel audio controls. If the ASWC-1 is not being used,
disregard this harness. If it will be used, please refer to the ASWC-1
instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.