Assembly - Hart HGSP01 Manual Del Operador

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
WARNING:
Do not use this product if any parts on the Packing
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer in-
stallation. Use of a product that may have been improp-
erly assembled could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-776-5191 for assistance.
PACKING LIST
Chemical Sprayer
Hose
Measuring Cap
Spray Wand Assembly (Includes o-ring, threaded coupling,
and nut)
Handle
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create ac-
cessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible seri-
ous personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the product when assembling parts.
CONNECTING THE SPRAY WAND TO THE
HANDLE
See Figure 2.
 Insert the spray wand into the the handle as shown.
 Slide the o-ring down until it touches the handle.
 Install the threaded coupling onto the handle and tighten
securely.
 Rotate the nozzle until it is aligned with the handle (point-
ing down) and ready for use.
 Slide the threaded coupling onto the handle and tighten
securely.
 Pull on the spray wand to be certain it is properly secured.
 Place the assembled handle into the handle storage area.
ATTACHING THE HOSE
See Figures 3 - 4.
To attach the hose to the tank:
 Slide the nut on the hose away from the hose end.
 Insert the hose end into the hose connector as shown.
Make sure the connection is secure.
 Slide the nut over the opening and hose end. Hand
tighten. Do not overtighten.
To attach the hose to the handle:
The hose comes preassembled to the handle. If it becomes
loose, follow the instructions below.
 Install the threaded coupling onto the handle and tighten
securely.
 Slide the nut on the hose away from the hose end.
 Insert the hose end into the opening on the threaded
coupling. Make sure the connection is secure.
 Slide the nut over the hose and threaded coupling. Hand
tighten. Do not overtighten.
6 – English