Bebesounds BE006 Manual Del Usuario página 8

RECORD YOUR BABY'S SOUNDS AND YOUR OWN
HEARTBEAT
With our recording cable and your own tape recorder your can record
your baby's sounds. We also encourage you to record your own
heartbeat prior to your baby being born. The sound of your heartbeat
will have a calming and soothing effect on your newborn baby.
OPERATION OF BÉBÉSOUNDS PRENATAL HEART
LISTENER (Refer to Figures 6 and 7)
1. Make sure the foam cover is in place on the listening cone.
2. Remove battery compartment door and install a new 9 volt battery
(not included) keeping the ribbon under the battery and exposed for
easy removal. Press battery forward and down. We recommend a
new alkaline battery as an old one will severely interfere with the
performance of your Monitor.
3. Insert the headphone plug into either jack on the Monitor.
4. Turn on BébéSounds using the ON/OFF volume control switch.
The red LED will light to indicate the unit is in the ON position.
5. Use the BébéSounds Monitor on bare skin in a quiet room.
6. Hold the conical-shaped detector to your stomach or back and press
and hold down the activation button. Adjust the volume to optimize
the listening level and amplification. Start with a low to moderate
setting to avoid static.
7. Release the activation button and gently move the Monitor one inch
at a time to different places until you find the best position for
listening to your baby's sounds. Start two inches below and several
inches to the right of your belly button.
8