GE Evolve EFH1 Guia De Instalacion página 2

1
UNPACKING
• This luminaire has been packed to ensure no damage
during transit.
• Inspect to confirm.
2
hANDLING
• Damage may occur if luminaire is improperly
handled outside of pack.
• Do not impact or stack luminaire after unpacking.
3
MOUNTING
Risk of injury or damage. Unit will fall if not installed
properly. Follow installation instructions.
3a. Pipe Mounted Units:
through 2-3/8-inch O.D. or 2-7/8 O.D. through 3-inch O.D.
pipes. Set screws clamp the floodlight securely to the
pipe. Tighten set screws to 15 foot-pounds (20.3 N•m).
Mount on a vertical pipe pointed upward such that
gravity acts to hold floodlight in place while the set
screws are tightened. Do not mount unit up-side-down.
FIGURE 1
• Open wiring compartment cover located on the
mounting bracket. Make electrical connections and
close wiring compartment cover.
Note: Make all electrical connections in accordance
with the National Electrical Code and any applicable
local code requirements.
3b. Wall Mounted Units:
has four .438-inch clearance holes spaced 4.375 (H) x
2.875 (V) inches for mounting. Do not mount the unit
such that the hinge side of door is higher than the
latch side of door.
WARNING
Mount on 1-7/8-inch O.D.
Wiring Cover
Set Screws
The wall mounting plate
2.875 in.
FIGURE 2
4 Holes
.4387 in.
• Open Wiring compartment cover located on the
mounting bracket. Make electrical connections and
close wiring compartment cover. Seal wall mounting
flange to the mounting surface with silicone, caulk,
or equivalent.
3c. Trunnion Mounted Units:
a flat surface. The Trunnion bracket has a clearance
hole for a customer supplied 3/4-inch bolt used for
attachment. Tighten side trunnion bolts to 15-20 foot
pounds after aiming.
Provision for Customer
Supplied 3/4" Bolt
Note: Make all electrical connections in accordance
with the National Electrical Code and any applicable
local code requirements.
Wiring Cover
4.375 in.
Mount directly on