Indel B TB Serie Instrucciones De Uso página 22

TB SE RIE S
M AINTE NAN CE
Before carrying out any maintenance operation on the refrigerator, take the power cable out of its
socket.
CLE ANIN G
• Regularly clean the inside and outside of the refrigerator using only warm water and a neutral detergent.
• Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.
• Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray detergents,
alcohol, ammonia or abrasive products.
• If you are not using the refrigerator, we suggest cleaning it well inside and leaving the door ajar to
ventilate the interior.
SUG G E S TIO N S
Should the device fail to work or work badly, before referring to our after-sales service, make sure that:
a) the feeding voltage is not missing;
b) the voltage is the same as the one shown on the plate;
c) the connections and the polarities are right;
d) the airing grids are not covered over;
e) the refrigerator unit is not near any heat source;
f) the fuse of the feeding line is not blown.
The power supply cable must be replaced only by qualified technical personnel and in any case by an
after sales service authorised by the Manufacturer..
Indel B is not liable in any way if you do not comply strictly with all the previsions in this manual.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
FAU LTS
ERROR CO DE
Battery protection or temperature sensor malfunction shutdown
E1
(The voltage is outside the cut-out setting).
Fan over-current cut-out
E2
(The fan loads the electronic unit with more than 1A
Motor start error
E3 (The rotor is blocked or the differential pressure in the refrigeration system is too high
(>5 bar)).
Minimum motor speed error
E4 (If the refrigeration system is too heavily loaded, the motor cannot maintain minimum
speed 1,850 rpm).
Thermal cut-out of electronic unit
E5 (If the refrigeration system has been too heavily loaded, or if the ambient temperature
is high, the electronic unit will run too hot).
TB_SERIES_24-01-2019
ERROR T YPE
peak
20
).