Preparations; Install Batteries; Prepare The Remote Control; Precautions Concerning Batteries - Power Acoustik HP-210i Manual De Instrucciones

Preparations

Install Batteries

Note:
- You can only use AC power as power supply.
Batteries ( not supplied ) are for backup purpose.
1
Open the batteries compartment.
2
Install two batteries (AAA) with correct polarity
as indicated.
3
Close the battery compartment.

Prepare the Remote Control

The provided Remote Control allows the unit to be
operated from a distance.
Even if the Remote Control is operated within

the effective range (6m), remote control
operation may be impossible if there are any
obstacles between the unit and the remote
control.
If the Remote Control is operated near other

products which generate infrared rays, or if
other remote control devices using infrared
rays are used near the unit, it may operate
incorrectly. Conversely, the other products may
operate incorrectly.
For First-time use:
The unit has a pre-installed lithium CR2025 battery.
Remove the protective tab to activate the remote
control battery.
To Replace the Remote Control Battery:
1
Pull out the battery tray and remove the old
battery.
2
Place a new CR2025 battery into the battery tray
with correct polarity (+/-) as indicated.
3
Insert the battery tray back into the slot.

Precautions Concerning Batteries

When the Remote Control is not to be used

for a long time (more than a month), remove the
battery from the Remote Control to prevent it
from leaking.
If the batteries leak, wipe away the leakage

inside the battery compartment and replace the
batteries with new ones.
Do not use any batteries other than those

specified.
Do not heat or disassemble batteries. Never

throw them in fire or water.
Do not carry or store batteries with other metallic

objects. Doing so could cause batteries to short
circuit, leak or explode.
Never recharge a battery unless it is confirmed

to be a rechargeable type.

Connect Power

Caution:
- Risk of product damage! Ensure that the power
supply voltage corresponds to the voltage printed
on the back or the underside of the unit.
- Before connecting the AC power cord, ensure
you have completed all other connections.
Connect the AC power cord to the wall socket.

Play

Power

You can use all the functions on the top of the unit or
the remote control after connecting to power supply
(called Standby Mode).
Note:
- You can only use AC power as power supply.
Batteries ( not supplied ) are for backup purpose.
- If the system is unplugged or if a power failure
occurs, all setups of the unit will be erased
unless there are batteries in the unit and don't
change them at this time. Once setups had be
erased, please re-setup all items ( tuner
stations;Source... ) which you desire.
Turn On
Press ON/OFF/SOURCE button to turn the
system on from standby mode.
Press ON/OFF/SOURCE to select different
functions.
Note:
When turning the system on, the system will
continue in the mode it was in when it was
turned off last time.
Turn Off
Press and hold ON/OFF/SOURCE button again
to turn the system off and go to standby mode.
Note:
Be sure to unplug the power cord from the outlet
when the system is not in use for an extended
period of time.
5