Set The Alarm Timer; Activate And Deactivate The Alarm Timer; Repeat Alarm; Stop Alarm Ring - Power Acoustik HP-210i Manual De Instrucciones

Set the Alarm Timer

You can set two alarms which go off at different time.
1 Ensure that you have set the clock correctly.
2 Press ALARM1 or ALARM2, [AL1
begin to blink.
3 Press / on the remote control to select an
 
alarm sound source: iPod/iPhone/iPad,
FM tuner, or buzzer.
4 Press ALARM 1 or ALARM 2. The hour digits
begin to blink.
5 Press / repeatly to set the hour.
 
6 Press ALARM 1 or ALARM 2. The minute digits
begin to blink.
7 Repeat steps 5-6 to set the minute.
8 Repeat steps 5-6 to select whether to ring alarm
the whole week, on weekdays, or at weekend.
9 Repeat steps 5-6 to set the alarm volume.

Activate and Deactivate the Alarm Timer

Press ALARM 1 or ALARM 2 repeatly to activate
or deactivate the timer.
- If the timer is activated, [AL1
is displayed.
- If the timer is deactivated, [AL1
[AL2 ] disappears.

Repeat Alarm

You can press to adjust the interval to repeat alarm.
When the alarm rings, press SNOOZE/DIMMER.
The alarm repeats ringing 9 minutes later.

Stop Alarm Ring

When the alarm rings, press the corresponding
ALARM 1or ALARM 2. The alarm stops but the
alarm settings remain.

View the Alarm Settings

Press ALARM 1or ALARM 2 to view the alarm
settings.

Set the sleep timer

This unit can switch to standby automatically after a
set period of time.
1 Press SLEEP repeatedly to select a set period
of time (in minutes).
- When the sleep timer is activated, the
display show
decrease before the unit power off.
2 Press SLEEP repeatedly until [OFF] is displayed.
- When the sleep timer is deactivated,
disappears on the display.
] or [AL2
] or [AL2
] or
, the volume will gradually

Adjust Display Brightness

Press DIMMER repeatedly to select different levels
of display brightness.
]

Adjust Volume Level

During play, press the VOL+/- buttons to increase/
decrease the volume level.

Select a Preset Sound Effect

During play, press the EQ button repeatedly to
select: [FLAT], [Pop], [Classic], [Rock], [Jazz]

Mute Sound

During play, press the MUTE button to mute or
restore sound. Press this button again to cancel the
effect.

Listening to the FM Radio

Tuning in a Station

1
Press the FM button to select the FM source.
]
2
Press and hold the
frequency changes down or up automatically
until a station is found.

Presetting Stations

You can preset up to 20 FM stations.
 Program radio stations automatically
Press and hold the PROG button for 2 seconds
to activate automatic programming. All available
stations are programmed in the order of
waveband reception strength.
- The first programed radio station is played
automatically.
 Program radio stations manually
1
Tune in the desired station, then press the PROG
button.
2
Press the
3
Press the PROG button to store the station.
4
Repeat above steps 1 to 3 for each station you
want to store in memory with a preset number.
Note:
- If the system is unplugged or if a power failure
occurs, the preset stations will be erased unless
there are batteries in unit and don't change
batteries at this time.

Tune to a Preset Radio Station

Press the

number that you want.
7
/ buttons, the
H G
/ buttons to select the preset number.
 
or buttons to select a preset
 