SP160_SP350.book Seite 23 Donnerstag, 22. Februar 2007 1:51 13
All manuals and user guides at all-guides.com
SinePower
➤ Connect the external switch to the remote port (fig. 2 2, page 4) in ac-
cordance with the following circuit diagrams:
– External switch, voltage supply from the inverter: fig. 3, page 4
– Control unit with relay or semiconductor circuit (TR): fig. 4, page 4
– External switch with voltage supply from the battery (BAT) of the
vehicle: fig. 5, page 4
– External switch with it own voltage supply (EVT PWR) e.g. from the
ignition: fig. 6, page 4
✓ If the inverter is switched on via an external switch, the LED (fig. 1 2,
page 3) lights up green.
Observe the following when using the device
During operation, if the battery voltage drops below 11 V for SP162/SP352
or 22 V for SP 164/354, a warning signal sounds and the LED (fig. 1 2,
page 3) flashes red. If the battery voltage falls further, the inverter switches
off.
If the inverter overheats, it switches off – the LED (fig. 1 2, page 3) flashes
red.
➤ If this happens, switch the inverter off with the switch.
When it cools down, you can use the inverter again.
When operating the inverter at a high load for lengthy periods, it is advisable
to start the engine in order to recharge the vehicle battery.
You can operate the inverter with the engine running or switched off. Howev-
er, do not start the engine while the inverter is switched on, since the power
supply to the cigarette lighter is disconnected during ignition.
8
Cleaning and caring for the inverter
Caution
Do not use any sharp or hard objects for cleaning since they may
damage the device.
➤ Occasionally clean the device with a damp cloth.
Cleaning and caring for the inverter
23