Ace 3196425 Manual De Instrucciones página 3

Basic Chime:
1. Remove batteries from chime.
2. Place chime against wall and verify the chime is level.
3. Use chime holes as a template (see Figure 5). Drill 7/32" diameter pilot hole
for 2 wall anchors (provided) and insert anchors.
4. Insert 2 screws (provided) through holes in back of chime.
5. Using arrow inside chime unit as a guide, mount chime with arrow pointing
up (see Figure 5). Do not tighten completely.
6. Verify chime is level and tighten screws securely.
7. Replace batteries (see Figure 3). Snap cover onto chime base.
Chime with Separate Decorative Cover:
1. Slide cover pin onto rear of chime as shown in Figure 6. Pin must be assem-
bled to base prior to mounting base to wall (pin may be pre-assembled).
2. Follow directions under "Basic Chime" to mount chime base to wall.
3. Hang cover on cover pin.
Top of Chime
598-1149-01
ON
1 2 3 4 5 6 7
Mount
Chime Unit
with Arrow
Pointing Up
ON
1 2 3 4 5 6 7
Figure 5
Back of Chime
Figure 6
-3-
for Wall
Mounting
ON
1 2 3 4 5 6 7
Cover Pin
Installed on
Chime Back
Cover Pin
Holes