Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
Floor _ Ranges of monitor configuration
1. Carry out the wiring of the DRP-2's following the "Installation" section and supply them.
2. Set the configuration switch in position 0.
3. Press the pushbutton PB1 for 4 seconds to enter programming.
4. DRP-2 will begin to emit "1 flash - 1 beep" every second.
Enter the code of the first monitor (lowest code in the range), of the floor that we want the
DRP-2 we are programming to control. Page 7.
Floor 5
23
Floor 4
Floor 3
Press the pushbutton PB1 for 2 seconds to validate the first code of the range.
5. El DRP-2 will being to emit "2 flashes - 2 beeps" every second.
Enter the code of the last monitor (highest code in the range), of the floor that we want the
DRP-2 we are programming to control. Page 7.
Floor 5
23
Floor 4
Floor 3
Press the pushbutton PB1 for 2 seconds to validate the last code of the range.
6. The DRP-2 will emit a long beep and go on to give 3 flashes every 6 seconds, indicating that
the programming of the range of monitors has been correct.
7. Repeat the same procedure for the rest of DRP-2 regarding their floors_ranges.
Once each range of monitors has been programmed in each DRP-2, see page 5 for the
configuration of the installation.
24
25
26
27
24
25
26
27
28
29
28
29
PB1
DRP-2 that controls
23
the floor 4
PB1
DRP-2 that controls
29
the floor 4
Bringing people together
Publicidad
Tabla de contenido
