Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PROJECTOR
1.
Fix the projector to the top of the Manhattan unit. The underside of the Projector has
an integral bracket (angled thin white metal bracket with a hole in) and a circular plate.
Pass the knob supplied through the hole in the bracket and into the hole in the middle
of the plate and then through the top of the Manhattan. Fasten with a wing nut.
2.
Put the effect wheel supplied into the wheel rotator.
3.
Slide the wheel rotator into the rear gate of the Projector.
4.
Switch the projector on at the back of the projector.
5.
Also on the top of the Manhattan is a small circular vent – do not block this vent.
BUBBLE TUBE
1.
Open the bottom cupboard using the keys supplied.
2.
Fill the bubble tube with clean water via the white socket in the base using the pump
supplied. Avoid filling the bubble tube from the top. Whilst this is possible, it is not
recommended as there are electronic components in the upper part of the
Manhattan. If you choose to ignore this recommendation, make sure that all the
electronic components are covered with a plastic sheet as it is imperative that water
is not spilled or splashed onto the components. Replace the top afterwards.
Publicidad
Tabla de contenido
