Usb Operation - Manhattan 130219 Guía De Instalación Rápida

SATA Quick Clone Dock • Quick Install Guide
Thank you for purchasing the MANHATTAN
This guide presents the basic steps for using this device. For detailed operating and
cloning instructions and specifications, refer to the user manual available at
www.manhattan-products.com.
Basic Setup & Offline Operation
1. Use the included power adapter to
connect the DC Input jack to an AC
power outlet.
2. Insert the source HDD in Bay A and
the target HDD in Bay B. NOTE: The
capacity of the target HDD must be
greater than the source
HDD.
3. When the A and B LEDs
light, set Power to On.
4. Press the Clone button for
3 seconds. When the LED
lights, press the Clone button again.
The LEDs indicate progress (25-100%).
All the LEDs light when complete.
5. Turn the power off and remove the
drives.

USB Operation

The software on the included CD needs
to be installed to use the Dock with your
PC. NOTE: This is PC-based software.
1. Use the included power adapter to
connect the DC Input jack of the Dock
to an AC power outlet.
2. Use either the included USB cable or
eSATA cable to connect the Dock to
the computer.
3. Insert an HDD (2.5" or 3.5") firmly into
the Dock. Depending on your operating system and the connection type, installation
messages may appear on-screen. NOTE: If using the eSATA interface, either bay can be
used for data transfer, but not both at the same time. If two HDDs are inserted in the
dock, only Bay A will be recognized.
4. Toggle the Power switch to On and confirm that the Power LED lights.
5. Insert the CD and follow the on-screen instructions or refer to the user manual.
2
English
SATA Quick Clone Dock, Model 130219.
®
power on/off dc input
disk disk
power
master slave
Bay A
(master/source)
Bay B
(slave/target)
English
Rear view: connections
usb sata
e
Front view: LED indicators
25% 50% 75% 100%
Top view: HDD bays
Clone
button