Marmitek DOORPHONE 150 Modo De Empleo página 9

gate Door Unit) will show steady in LCD on the handset once
pairing is successful. The call indicator
back gate Door Units should stop flashing and remain steady on.
5. Long press the Power ON/OFF button
handset. Take out the alkaline batteries from the Door Unit and
then re-install again or connect to the power supply.
6. The doorphone is now ready for operation.
If the pairing process is not successful (the "
the LCD of the handset), repeat the procedures from step 1 again.
N.B. In case you are having two or more handsets as well as a back
gate Door Unit, always perform the pairing process with all Door
Units and handsets together and with the handsets being set in
pairing mode first.
Remember every time you add on new units to the system, either
handset or Door Unit (for back gate use), it is necessary to perform
the pairing process all over again with all the units together or
otherwise the new units will not work with your original system.
DoorPhone 150
on both front gate &
to switch off the
" continues to flash in
9