Skoda 3T9 056 700 Instrucciones De Montaje página 33

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
- Press the rubber part of the sleeve (C) against yourself and
open it.
- Seat the sleeve with the rubber part (in the driving direction)
on the bicycle seat tube and snap. For vehicles Škoda Su-
perb Combi (3T) with mounting tray with sliding elements
or with false floor, firstly put the bicycle seat in the lowest
GB
possible position.
- Snap the snap hooks on the ends of the strap (C) into the
fastening loops at the floor of the vehicle or into the sliding
elements (as per the vehicle type).
- Snap the strap out carefully on both sides.
Attention. Never use the snap hooks for fastening the
loop strap for snapping the back seat rests. Always use
the fastening loops at the car floor (for fastening the net
programme) or the fastening elements on the mounting
trays or the loops on the bicycle holder crosspiece!
- 17, 18 -
- Example of fixing a bicycle in the interior bicycle holder
- according to the type of the car.
- 19 -
- Fixing a bicycle in the interior bicycle holder for vehicle
Škoda Octavia Combi (1Z). Fasten the bicycle in the bicycle
holder in the same manner as in case of other types of ve-
hicles. Snap the snap hooks (C) into the loops on the bicycle
holder crosspiece.
- Run the additional strap (E) across the bicycle handle bars
pre-piece. Make sure the washer on the strap was fastened
on the pre-piece of the bicycle handle bars. Snap the snap
hooks of the strap into the fastening loops at the floor of
the vehicle.
- Snap the strap out carefully on both sides.
Attention (for all vehicles).
If the strap (C) or the additional strap (E) (for vehicles
Škoda Octavia Combi) is not switched off correctly (un-
tightened) disturbing noise might occur during the
drive. The efficiency of the strap is reduced by incorrect
disconnection. Therefore we recommend to stop after a
longer drive and check the dicsonnection of the straps.
- 20 -
Securing of bicycles by straps if 2 bicycles are transported.
- If you transport two bicycles, adjust the strap between the
bicycle seats to correct length. To fasten the snap hooks into

Publicidad

Tabla de contenido
loading

Tabla de contenido