Celestron 44306 Manual De Instrucciones página 5

1. Carefully remove the microscope and other parts from the box and set
them on a table, desk, or other flat surface.
2. Remove the plastic bag covering the microscope.
3. Remove the plastic plug up cap from the eyepiece tube and install the
eyepiece (remove the cap from the eyepiece) – see
Figure 1.
4. Install the batteries for the illuminator in the rear of the
microscope which uses two AAA batteries (user
supplied).
compartment. Install the batteries (see the inside of the
battery compartment where the positive (+) and negative
(-) ends of the batteries go.
You are now ready to use your microscope for looking at specimen slides or
objects through the microscope eyepiece as an optical microscope! For
using the digital (CMOS) camera, installation and operating instructions
will follow later in this manual.
Setting Up Your Microscope
See Figure 2 showing the open battery
5
Figure 2