Publicidad
Idiomas disponibles
Idiomas disponibles
Part No.
Description
Qty
1
Frame
2
Square tube
3
Cap
4
Supporting foot
5
Swivel caster with brake
6
Support roller
7
Strut
8
Knob
9
Axle
10
Scissor mechanism
Safety Instructions:
1.
Be careful when moving to limit any finger pinch points.
2.
Place base on a level surface and adjust levelers before placing the conveyor in position. This
should keep the unit from rocking, while testing it for stability.
3.
Exercise caution when testing the stability of the conveyor
4.
Unplug any power tool before moving or repositioning your tools.
5.
Always test your set-up for stability and safety after repositioning.
6.
Care should be taken when planning the orientation of the conveyor when used in conjunction
with a machine. Be certain that your setup is safe before beginning production.
7.
Never use your conveyor without engaging the caster wheel locks.
8.
When moving your conveyor, always remove working materials from the top.
Part No.
Description
2
11
Connecting hook
2
12
Ring
4
13
Carriage bolt
4
14
Bolt
4
15
M8 bolt
9
16
Hex Nut
4
17
Hex Nut
4
18
Washer
18
19
Nyloc retaining nut
2
20
Nyloc M8 retaining nut
21
Washer
Quick Start Guide
Before using the conveyor roller for the first time – insert the sup-
port legs 4 into the main frame 1. You can secure the legs with the
knobs 8. Once the conveyor is assembled use the following guide-
lines for proper usage.
1. The conveyor is only to be used on level surfaces.
2. Position the conveyor into the required position and apply the
brakes on the end where material will be loaded.
3. Expand the unit to the desired length and apply the brake to the
other two casters at the opposite end.
4. Raise or lower the unit to the desired height and tighten the knobs
to lock it in place.
5. If you are using multiple units secure them in place using the con-
necting hook and repeat steps 1 to 4 to ensure the units are se-
cure and in the correct position for the work you are completing.
Qty
6. Place the material to be transported carefully on the rollers mak-
2
ing sure that they are supported correctly.
2
4
2
4
4
4
4
18
4
4
8
1
4
Publicidad
