Aligning The Wall Plate - Samsung ME21K6000AS Instrucciones De Instalación

Step-by-step installation guide
D. ALIGNING THE WALL PLATE
Horizontal Line
Horizontal Line
CAUTION: Wear gloves to avoid cutting
CAUTION: Wear gloves to avoid cutting fingers fingers on sharp edges.
on sharp edges.
1. Draw a horizontal line on the wall at the
bottom of the "Rear Wall Template".
2. Drill ⅝" holes for toggle bolts in 3 locations
(Hole A, Hole B, Hole C) as shown in the
illustration above. If the location of a hole
lines up with a stud, drill a
wood screw. You cannot use a toggle bolt to
attach the wall plate to a stud.
NOTE: DO NOT MOUNT THE PLATE AT
THIS TIME.
ME21K6000AS_AA_DE68-04108C-00_EN.indd 10
Centerline
Draw a vertical line on the Draw a Vertical Line
Hole A Hole A Centerline
notches
on Wall from Center
wall to mark the center of
notches
of Top Cabinet
the cabinet above.
C L
Area E
Area E
Draw a horizontal line on the wall along the bottom of
Draw a Horizontal line on wall from
the "Rear Wall Template".
bottom of "Rear Wall Template".
3. Holes A, B and C are inside area E. If none
of these holes line up with a stud, find a stud
in area E that lines up with a hole circle in
Area E, and then drill a
a wood screw. You must have at least one
wood screw mounted firmly into a stud to
/ " hole for a
3
16
support the weight of the microwave. Set
the mounting plate aside.
10
Horizontal Line
Hole B Horizontal Line
Hole B
/ " hole into it for
3
16
5/20/2016 5:06:31 PM