Step-By-Step Installation Guide; Placement Of The Mounting Plate; Removing The Microwave Oven From The Carton/Removing The Mounting Plate; Finding The Wall Studs - Samsung ME21K6000AS Instrucciones De Instalación

Step-by-step installation guide

1. PLACEMENT OF THE MOUNTING PLATE

A. REMOVING THE
MICROWAVE OVEN FROM
THE CARTON/REMOVING
THE MOUNTING PLATE
1. Remove the installation instructions, Exhaust
adaptor, filters, glass tray, and the small
hardware bag. Do not remove the Styrofoam
protecting the front of the oven.
2. Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton
over onto the top side. The oven should be
resting in the Styrofoam.
Styrofoam
Styrofoam
3. Pull the carton up and off the oven.
4. Remove and properly discard plastic bags.
Screws
Screws
Mounting Plate
Mounting Plate
5. Remove the 2 screws from the mounting plate.
This plate will be used as the rear wall template
and for mounting.
NOTE: Retain the two screws. You will need to re-
insert the screws in their original locations after you
have removed the mounting plate.
ME21K6000AS_AA_DE68-04108C-00_EN.indd 8
Carton Carton
Screws
Screws
8
B. FINDING THE WALL STUDS
Wall Studs
Wall Studs
Center
Center
1. Find the studs using one of the following
methods:
A. With a stud finder – a magnetic device which
locates nails.
OR
B. Use a hammer to tap lightly across the
mounting surface until you hear a solid
sound. This will indicate a stud location.
2. After locating the stud(s), locate the stud's center
by probing the wall with a small nail to find the
edges of the stud. Then, place a mark halfway
between the edges. The center of any adjacent
studs should be 16" or 24" from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
5/20/2016 5:06:30 PM