Publicidad
Idiomas disponibles
Idiomas disponibles
To continue the wash, carry a new basket, introduce it
in the machine, close the door and press button
"C".
Endless cy cle (maximu m 15 minutes) : the door
-
being closed and the cycle put on (any cycle), keep the
button "B" pressed for 3 seconds: lamps 1 and 2 will
flash at the same time (thermocontrol excluded); the
cycle can be interrupted at any time pressing again
button "C" that will let final sequences of pause-rinse
start.
Self-washing cycle : Remove the overflow from the
-
tank and close the dishwasher door while the machine
is on (time 10 minutes).
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. An
insufficient rinsing might cause any halos: in this
case, check that the rinsing jets are clean and
there is a sufficient pressure in the water
distribution network (ideal is between 2-4 bar).
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• filters are clean
• the position of the dishes in the rack is correct
(look at the specific paragraph).
DISHES POSITIONING
It is suitable to place dishes, inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into the
suitable container minding not to cram them and
with
handgrips
towards
drawing).
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightener).
Your cleansing agent supplier will be able to
suggest
the
most
machine is equipped with a rinse aid dispenser.
Mean concentration used is 0,15 g/liter.
the
bottom
(see
suitable
product.
Your
REGENERATING
(for machines with Water softener)
If the glass-washer is equipped with a Water
softener the
automatic according to parameters fixed by the
producer (this operation is signalled by lighting
up of led "D").
According to the water hardness, it is possibile
to modify the programming of the regeneration.
See the corresponding table in the installer
section.
SALT CONTROL
When it is necessary to add salt in the container,
the lamp "D" flashes.
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it. Clean the gasket and screw the plug.
Attention!
The lack of salt in the container damages the
machine
because
defective washing of glasses and dishes.
These damages are not covered by the warranty.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to drain the exceeding
water coming from the rinsing cycle.
At the end of the w
completely drain the tank,
perform the following operations:
1.Switch the machine off by keeping pressed the
main switch "A" for 2 seconds (cycle
pushbutton becomes red);
2.Open the door of the dishwasher;
3 .Remove the overflow from the tank;
4.Afterwards push button "C" for 3 seconds.
Pushbutton "C" flashes with sky-blue colour.
The drain will stop automatically after 5 minutes
(cycle pushbutton is red).
Reinstall the overflow and close the door.
22
regeneration of resins
of
limestone,
besides
orking day , in order to
it is necessary to
is
a
Publicidad
