Publicidad
Installation Process:
Note: It is highly recommended that you read all owner's manuals and test all equipment
with the intended source and sink devices before permanently installing products.
1.
Remove power from all equipment involved in the installation process.
2.
Reference Installation Instructions, Steps 1-2, for Wiremold A/V Table Boxes –
C2G Integration Bracket. Attach the Wireless A/V System TX to the Wiremold
A/V Table Boxes – C2G Integration Bracket. Use the hook and loop pads
included in the Wireless A/V system.
3.
Reference Installation Instructions, Steps 3-4, for Wiremold A/V Table Boxes –
C2G Integration Bracket. Attach the Wiremold A/V Table Boxes – C2G
Integration Bracket to the Wiremold InteGreat A/V Table Box, by sliding the
mounting hooks of the bracket into the side of the table box with 4 cut outs.
Finish mounting by inserting the included rivets.
Tech Tip: The Wiremold A/V Table Boxes – C2G Integration Bracket has
opening where you can attach cables for proper strain relief.
4.
Reference Installation Instructions, Step 6a, for Wiremold A/V Table Boxes. This
step will require 3/32" Allen Wrench. Feed the 6ft Ultra Flexible High Speed
HDMI Cable through the opening of the device plate (opening with ten screw
holes). Place Cable Kit plates around cable and attach to device plate using
(2) #4-40 screws in each plate. Attach remaining Cable Kit plates to device
plate. Place grommet around the HDMI cable and snap into hole in Cable Kit
plate. Snap remaining grommets into the empty holes.
Tech Tip: Placing the HDMI cable through the grommet opening closest to the
front edge (handle side) will allow a smoother feed of the cable.
5.
Reference Installation Instructions, Step 2, for Wiremold A/V Table Boxes. This
step will require Phillips Screw Driver. Install device plate into A/V Table Box
using (4) #8-32 screws. Select the device plate level (refer to illustrations with
Tables 2A and 2B in the Wiremold A/V Table Boxes Installation Instructions).
The device plate should be installed at deeper settings to accommodate
cable bend radius and allow the cover to close while the box is activated.
6.
Attach the 6ft Ultra Flexible High Speed HDMI Cable to the Wireless A/V
system TX.
7.
Reference Installation Instructions, Step 5, for Wiremold A/V Table Boxes. This
step will require Phillips Screw Driver. Feed device box power cord through the
right side opening in the device plate (opening with four screw holes). Attach
power supply to device plate using (4) #4-40 screws.
8.
Plug the 2 Port USB Wall Charger into AC outlet facing under table in the A/V
Table Box.
Publicidad
