Publicidad
9.
Connect Power to the Wireless A/V system TX by using the included USB-A to
Micro-B cable. Connect USB A to the 2 Port USB Wall Charger and connect
Micro-B to the Wireless A/V System TX.
Tech Tip: Remember to route the power wire as to not interfere with cabling,
especially the HDMI cable fed through the grommets.
10.
Reference Installation Instructions, Step 3, for Wiremold A/V Table Boxes. This
step will require Drill and Jigsaw. Install A/V Table Box using the provided
table box installation template.
a.
Cut a 6 7/16" x 5 ½" (164mm x 140mm) opening using the template
provided.
11.
Install A/V Table Box into opening in table.
12.
Reference Installation Instructions, Step 4, for Wiremold A/V Table Boxes. Place
mounting brackets into slots on sides of A/V Table Box. Tighten thumb
screws against the bottom of the table.
13.
Reference Installation Instructions, Step 7, for Wiremold A/V Table Boxes. Snap
faceplate onto device plate to finish installation. (In order to insert the
faceplate into the box, the cover must be lifted up slightly).
14.
Connect power cord for A/V Table Box power bank to AC outlet.
15.
Attach Wireless A/V system RX to display using the included adhesive pad.
RX may be attached to wall/display or mount.
16.
Attach the HDMI cable, included with the Wireless A/V system, to A/V
System RX and TV HDMI input port.
Tech Tip: Make note of the HDMI input port for later use.
17.
Connect Power to the Wireless A/V system RX by connecting the USB
Micro-B end of the USB power cable that is provided to the power port of
the receiver unit. Connect the USB-A by using either a USB AC adapter to
an available wall outlet, or an available USB port on the display.
18.
Apply power to Display.
a.
Remember to change Display input to proper HDMI input port.
19.
Allow a couple of minutes for the A/V System TX and RX to pair. System
will then be ready for use.
Publicidad
