Campbell Hausfeld TL050389 Manual De Instrucciones De Operación página 3

Operation (continued)
regULATOr
Some air hammers are equipped with a
built-in air regulator to reduce the blow
rate. It is located next to the air inlet.
Turn the knob counter-clockwise for
the fully open, highest speed. Gradually
turn the knob clockwise to reduce the
speed (See Figure 3).
Air Inlet
Regulator
figure 3
maintenance
STOrAge
The chisel/hammer must be lubricated
before storing. Follow the air piston
lubrication instructions with an
exception to step 3. Only run the chisel/
hammer for 2 to 3 seconds instead of 7
to 10 seconds because more oil needs
to remain in the chisel/hammer when
storing.
TecHnIcAL ServIce
For information regarding the
operation or repair of this product,
please call 1-800-543-6400.
repLAcemenT pArTS InfOrmATIOn
For information regarding where to
order replacement parts, call toll free
1-800-543-6400. Please provide the
following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
3
nOTe: Hammers are not included with
some tools. Any hammer with a .401
Parker taper shank size can be used.
Campbell Hausfeld offers five commonly
used hammers (Part number PA1003 or
MP2875*).
*PA1003 is a five piece set of hammers
each six inches in length. MP2875 is a 4
piece set of hammers each three inches in
length (does not include the sheet metal
cutter).
figure 4 - Hammer bits
www.chpower.com
TL050389
Weld Buster
Splitter
Punch
Flat
Sheet Metal
Cutter