Vollrath Instacut 5.1. Manual Para Operadores página 3

OPERATION (CONTINUED)
6. Check for proper blade alignment by slowly setting the pusher head
onto the blade assembly.
Correct - The pusher block passes between the blades.
Incorrect - The pusher block contacts the blades.
CLEANING
WARNING
Sharp Blade Hazard
Blades are sharp and can cause cuts. To avoid injury from
sharp blades, handle with caution.
NOTICE: Food acids will dull the blades and corrode the metal.
Clean this equipment immediately after every use.
NOTICE: Do not put this equipment in a dishwasher or dish machine
with soaps, detergents, or other alkaline chemicals that
can harm the equipment.Handwash only.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads to clean this equipment. These can damage
the finish.
Disassemble
1. Slide the pusher head assembly up and off of the guide rods.
2. Loosen the two thumbscrews. Thumbscrews are captive – do not
attempt to remove them. Separate the pusher block from the pusher
head.
™
Instacut 5.1 Slicer, Dicer, Wedger and Corer Operator's Manual
7. Lift the T-handle and place the food product on the blade assembly
with the flat side facing down.
8. Using a strong, quick, downward thrust, push the food through the
blade assembly.
9. Repeat this process until you have prepared enough food.
10.Clean and lubricate this equipment immediately after each use. See
the Cleaning section of this manual for more information.
3. Raise the bumpers approximately 2" (5.0 cm).
4. Loosen the thumbscrew and carefully remove the blade assembly.
Wash
1. Wipe, rinse or spray off the base, pusher head, pusher block and
blade assembly thoroughly with HOT water.
2. Do not wipe across the blades.
NOTICE: Wiping across the sharp edge of the blade can cause
injury and will dull the blades.
3. Use the included cleaning tool to push food particles out from the
pusher block or blade assembly.
4. Let the equipment air dry.
Reassemble
1. Return the cleaning tool to the pusher head assembly and
reassemble the pusher head assembly.
2. Install the blade assembly into the base. Tighten the thumbscrew to
push blade securely against the frame.
3. Lubricate the guide bar with mineral oil or Petrol-Gel.
NOTICE: Do not use cooking oil as it will become sticky and may
permanently damage the equipment.
4. Slide the bumpers into place.
3