Sovereign S-22-DGP-E-S Instrucciones De Instalación página 5

SECURING THE SAFE
NOTE: is safe must be secured to the oor.
Use the hardware provided.
NOTE: is safe must be mounted to the oor.
Failure to do so will compromise the safety and
security of the safe.
WARNING: Because this safe is
waterproof it will oat if not secured.
As the water level rises, the safe will
begin to oat and could fall over
causing personal injury.
e safe must be fastened to the oor using the lag
bolts and gasket washer provided with this safe to
insure the waterproof rating. Failure to do so will
void the waterprooof rating.
You must remove the safe om the skid/legs and
place the safe on the oor. Failure to do so will void
the re and waterproof ratings.
Place the safe in the desired location. When your safe
is open, you will nd 2 plastic disks covering the
mounting hole locations in the oor of the safe.
Remove the plastic disks to uncover the mounting
holes. ese holes are lled with re resistant
caulking which must be drilled out before mounting
the safe to the oor. Use a 3/8" diameter drill bit to
drill out this caulking. Continue to use this drill to
mark the hole location on the oor. Move the safe
away. Drill pilot holes in the oor as follows: For a
wood oor drill 5/16" diameter x 2-1/2" deep pilot
holes. For a masonry oor drill 7/16" diameter x
2-1/2" deep pilot holes for the anchors.
IMPORTANT: When you drill out the re resistant
caulking om the mounting hole you must mount
the safe to the oor using the lag bolts and gasket
washers. Failure to do so will void the re rating
and waterproof rating.
Reposition the safe and secure the safe with the lag
bolts and gasket washers. Replace the hole covers.
5
18
40664-1511