Maintenance - Snapper BL48 Manual Del Propietário

MAINTENANCE

W A R N I N G
In order to avoid personal injury and the risk of fire and electric shock, remove
the battery pack before adjusting, inspecting, or cleaning the blower.
Cleaning
Remove the battery pack.
1. Brush or blow dust and debris out of the air vents using compressed air
or a vacuum. Keep the air vents free of obstructions, sawdust, and wood
chips. Do not spray, wash, or immerse the air vents in water.
2. Wipe off the housing and the plastic components using a moist, soft
cloth. Do not use strong solvents or detergents on the plastic housing or
plastic components. Certain household cleaners may cause damage,
and may cause a shock hazard.
Battery Pack
• Store the battery pack fully charged.
• Once the light on the charger turns solid green, remove the battery from the
charger and disconnect the charger from the outlet.
• Do not store the battery pack on the tool.
• After charging, the battery pack may be stored in the charger, as long as the
charger is not plugged in.
Charger Maintenance
• Keep the charger clean and clear of debris. Do not allow foreign material to
get into the recessed cavity or onto the contacts. Wipe the charger clean
with a dry cloth. Do not use solvents or water, and do not place the charger
in wet conditions.
• Unplug the charger when there is no battery pack in it.
• Fully charge the batteries before placing them in storage.
• Store the charger at normal room temperature. Do not store it in excessive
heat. Do not use the charger in direct sunlight. Recharge at room
temperature between 43˚F and 104˚F (6˚C and 40˚C). If the battery pack is
hot, allow it to cool down inside of the charger.
14