Model 8142 - Test Mode - Aprilaire 8142 Instrucciones De Instalación Y Funcionamiento

MODEL 8142 – TEST MODE
After wiring and set up have been completed, Test Mode can be used to verify that all components in the ventilation system function and that wiring
to the HVAC system fan is correct .
1
Hold for 5 seconds .
TABLE 2 – MODEL 8142 TEST MODE MENU
Test Sequence Description
Shows - - - - °F to indicate that no separate outdoor temperature sensor has been installed . Model 8142 installations do not require a
HP °F
HC %
separate sensor – outdoor temperature is measured by the control's on-board sensor .
tESt shows on the display, the green Fresh Air LED will light and either the damper will open or the power ventilator will turn on
depending on what has been wired to the VENT terminals .
After 15 seconds, the HVAC fan will turn on if it has been wired and set up to do so . The display will show FAN along with tESt .
MEASURED REQ'D CONT CFM FAN
CODE
After 45 seconds Test Mode automatically completes and the display returns to the operating display .
MIN/
HR
10 English
2 3