Kenmore 51282 Manual De Uso Y Cuidado / Instalacion página 11

4. Drill a 1/8" dia. pilot hole for house wiring,
at A location on template.
5. Use a sharp pencil or 1/8" drill bit to mark the
locations for the appropriate duct access holes
(16 locations for 7" round duct, or 4 corner locations
for rectangular duct). Remove the template.
FRAMED CABINET
Refer to the marking on the brackets to determine
the correct installation side and orientation.

Mate the corresponding bracket to the cabinet
side frame, while placing rear end of bracket
against the wall. Use a pencil to mark 3 holes
(there are 6 holes but only 3 are necessary).

Remove the bracket. Using a 7/64" drill bit,
drill 3 holes where marked.
6. Draw the border for the exhaust ducting by linking its
marks (16 for round duct and 4 for rectangular duct),
then cut the opening in the cabinet bottom (vertical
exhaust) or in the wall (horizontal exhaust). Drill the
house wiring hole by using a 1½" hole saw centered
with the pilot hole previously made in 4.
7. Install the proper installation brackets according to
the type of cabinet (framed or frameless). See below.
7/64"

Assemble the bracket to the side frame using a
Phillips screwdriver and 3 provided no. 8 x 5/8"
wood screws. Repeat for the other side frame.
11