Accessories And Attachments; Available Accessories - Craftsman professional 152.221240 Manual Del Operador

ACCESSORIES AND ATTACHMENTS

AVAILABLE ACCESSORIES

Visit your Sears Hardware Department or see the Sears
Power and Hand Tool Catalog for the following acces-
sories.
ITEM
* Miter Gauge Extension & Stop
* Stock Clamp, Miter Gauge
* Table Insert - Standard
* Table Insert - Dado
* Table Insert - Molding Cutterhead
* Saw Blade - Leitz; 10-in. x 40 tooth,
Variable Pitch Blade
* Fence Guide System
Fig. 2A
Figure 2A illustrates dimensions for making a typical
featherboard. The material, which the featherboard is
constructed of, should be straight piece of wood that is
free of knots and cracks. Featherboards are used to
keep the work in contact with the fence and table and
help prevent kickbacks. Clamp the featherboard to the
fence and table so that the leading edge of the feather-
board will support the workpiece until the cut is com-
pleted.
WARNING
Use featherboards for all non-through cutting opera-
tions where the guard and splitter assembly must be
removed. Always replace the guard and splitter
assembly when the non-through cutting operations
are finished. See figure 2B.
STOCK NUMBER
29879
29880
29882
29885
29887
29888
32371
CONSTRUCTING A FEATHERBOARD
9
Sears may recommend other accessories not listed in
this manual.
See your nearest Sears Hardware Department or Sears
Power and Hand Tool Catalog for other accessories.
Do not use any accessory unless you have completely
read the Owner's Manual for that accessory.
WARNING
Use only accessories recommended for this table saw.
Using other accessories may cause serious injury and
cause damage to the table saw.
Fig. 2B