Groeneveld Multiline AC Manual De Instalación, Uso Y Montaje página 7

The AC15/AC25 can be programmed
by pressing and holding the manual
override button, located on the top of
the pump (see 'B' , below right).
If the button is pressed for 10 seconds
the programming mode will be
selected and the LED (positioned in
viewing window 'A' , below right) will
either flash Red or be continuously
lit red (depending on the current
programming setting). The Red
illumination or flashing of the LED
indicates that the pump is in the
programming mode and is showing the
current programming setting.
If the LED is continuously lit Red this
indicates that setting '0' is selected
(continuous run mode). If the button
is not pressed again within 30 seconds
the program will store this setting and
revert to it's operating mode. The pump
will 'Run' or operate on this setting.
However, if the button is pressed and
released within the 30 second window
the next setting will be selected. See
the table above for setting details and
timings.
For each setting the number of flashes
from the Red LED indicates the setting
selected. For example, for setting 1 the
LED flashes Red once and delays for 3
seconds, until flashing once again. For
setting 6 the LED will flash Red six times
before a 3 second delay and it will—
continue doing this for 30 seconds.
The setting will then be stored and
the pump will operate to the setting
selected or, if the manual override
button is pressed (within 30 seconds)
the next setting will be selected.
LED Flash patterns in programming mode
On
Setting 0
Off
On
Setting 1
Off
1s typ 3s typ
On
Setting 2
Off
1s typ 3s typ
1s typ
On
Setting 3
Off
1s typ
1s typ 3s typ
On
Setting 4
Off
1s typ
1s typ
On
Setting 5
Off
1s typ
1s typ
On
Setting 6
Off
1s typ
1s typ
A
Multiline AC
TIME
TIME
TIME
TIME
TIME
3s typ
TIME
3s typ
TIME
3s typ
B
F219157R03
EN
7