Maktec MT062 Manual De Instrucciones página 5

Ocultar thumbs Ver también para MT062:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Reversing switch action
A
1
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for counter-
clockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
operation.
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
reversing switch lever to the neutral position.
Speed change
For model MT062 and MT063
3
4
5
1
To change the speed, first switch off the tool and then
slide the speed change lever to the upper side for high
speed ("2" marking) or lower side for low speed ("1"
marking). Be sure that the speed change lever is set to
the correct position before operation. Use the right speed
for your job.
1. Reversing
003951
switch lever
B
1
1. Speed change
003353
lever
For model MT064 and MT065
1
To change the speed, first switch off the tool and then
slide the speed change lever to the lower side for high
speed ("2" marking) or upper side for low speed ("1"
marking). Be sure that the speed change lever is set to
the correct position before operation. Use the right speed
for your job.
CAUTION:
Always set the speed change lever fully to the
correct position. If you operate the tool with the
speed change lever positioned half-way between
the "1" marking side and "2" marking side, the tool
may be damaged.
Do not use the speed change lever while the tool is
running. The tool may be damaged.
Adjusting the fastening torque
1
The fastening torque can be adjusted in 20 steps by turn-
ing the adjusting ring so that its graduations are aligned
with the pointer on the tool body. The fastening torque is
minimum when the number 1 is aligned with the pointer,
and maximum when the
pointer.
The clutch will slip at various torque levels when set at
the number 1 to 19. The clutch is designed not to slip at
the
marking.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
NOTE:
Do not operate the tool with the adjusting ring set
between the number 19 and the
tool may be damaged.
5
1. Speed change
003952
lever
1. Graduations
003953
2. Drill marking
2
3. Adjusting ring
3
4. Pointer
4
marking is aligned with the
marking. The

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mt063Mt064Mt065

Tabla de contenido