Descargar Imprimir esta página

Clover Mini Guía De Funciones página 45

Ocultar thumbs Ver también para Mini:

Publicidad

FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
(2) This device must accept any interference received, including interference
that may cause undesired operation.
FCC Part 15 Class B-specific
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC exposure limit compliance statement (SAR statement)
This equipment complies with radio frequency (RF) exposure limits adopted by
the Federal Communications Commission for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20
cm between the radiator & your body.
Industry Canada Compliance
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
The device could automatically discontinue transmission in case of absence of
information to transmit, or operational failure. Note that this is not intended
to prohibit transmission of control or signaling information or the use of
repetitive codes where required by the technology.
The device for operation in the band 5150–5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile
satellite systems;
The maximum antenna gain permitted for devices in the bands 5250–5350
MHz and 5470–5725 MHz shall comply with the e.i.r.p. limit; and
The maximum antenna gain permitted for devices in the band 5725–5825
MHz shall comply with the e.i.r.p. limits specified for point-to-point and
non point-to-point operation as appropriate.
In addition, high-power radars are allocated as primary users (i.e. priority
users) of the bands 5250–5350 MHz and 5650–5850 MHz and that these
radars could cause interference and/or damage to LE-LAN devices.
L'appareil pourrait automatiquement interrompre la transmission s'il n'y
a aucune information à transmettre ou en cas de panne fonctionnelle. À
noter que l'objectif de cette disposition n'est pas d'empêcher la transmission
d'informations de contrôle ou de signalisation, ou encore l'utilisation de codes
répétitifs exigés par la technique.
L'appareil fonctionnant dans la bande comprise entre 5 150 et 5 250 MHz
est uniquement réservé à une utilisation en intérieur, afin de réduire le
risque d'interférences nocives aux systèmes mobiles par satellite utilisant
le même canal ;

Publicidad

loading

Productos relacionados para Clover Mini