Handle Assembly; Wheel Assembly - Campbell Hausfeld HL4330 Manual De Instrucciones

assembly

HANDLE ASSEMBLY

Figure 4

WHEEL ASSEMBLY

Washer
Nut
Figure 5
INTAKE FILTER
Figure 6
LUBRICATION
Figure 7
1. Place ends of handle around tank and into the mounting pipe. Align
holes in handle to holes in mounting pipe.
2. Assemble two (2) knobs (from parts package) through holes in
mounting pipe and handle. Tighten.
Axle Iron
Wheel assembly kit includes:
Wheel
• 2 wheels *
• 2 axle bolts *
• 2 washers *
• 2 nuts *
The items marked with an asterisk (*) were shipped loose with the
unit.
Axle Bolt 1. Wheel has an offset hub. Place wheel insert into center of hub.
With offset hub facing axle iron, assemble axle bolt through the
holes in wheel and axle iron.
2. Then tighten nut securely to threaded part of axle bolt.
3. Repeat procedure with other side.
Thread the intake air filter into the threaded opening in the side of the
compressor head.
THIS UNIT IS SHIPPED WITHOUT OIL! CHECK FOR PROPER
OIL LEVEL BEFORE OPERATING!
Use oil shipped with the compressor. Do not use regular automotive oil such
Max.
as 10W-30. Additives in regular motor oil can cause valve deposits and reduce
pump life. For maximum pump life, drain and replace oil after the first hour of
Min.
run time.
The compressor pump takes approximately 250ml (8.18 oz.) of oil. The sight
glass, located on the crankcase portion of the pump, is used to determine
proper oil level. Fill the crankcase with oil until the level is in the middle of the
sight glass. Avoid overfilling by adding oil gradually and checking the oil level
with the sight glass several times. Add enough oil to reach the "max" level on
the sight glass.
10
Never use the handle to lift the unit completely off the
ground. Only use the handle to lift one end so the
wheels may be used to move the unit.