Operation; Assembly - Campbell Hausfeld HU3508 Serie Manual Del Usuario

Operating Instructions and Parts Manual
Installation (Continued)
grounding reduces risk of electrical shock by providing an
escape wire for electric current. This product
is equipped with a cord having a grounding
wire with an appropriate grounding plug. Plug
must be plugged into an outlet that is properly
installed and grounded in accordance with all
local codes and ordinances.
Overheating, short circuiting and fi re
damage will result from inadequate wiring.

Assembly

HANDLE ASSEMBLY (Figure 3)
1. Place ends of handle around tank and into the mounting
pipe. Align holes in handle to holes in mounting pipe.
2. Assemble two (2) screws (from parts package) through
holes in mounting pipe and handle. Tighten screws.
Never use the handle to lift the unit
completely off the ground. Only use the
handle to lift one end so the wheels may be
used to move the unit.
Figure 3 - Handle Assembly
www.campbellhausfeld.com
Screws
WHEEL ASSEMBLY (Figure 4)
Wheel assembly kit includes:
- 2 wheels *
- 2 axle bolts *
- 2 washers *
- 2 nuts *
The items marked with an asterisk (*) were shipped loose with
the unit.
1. Wheel has an offset hub. Place wheel insert into center of
hub. With offset hub facing axle iron, assemble axle bolt
through washer and then holes in wheel and axle iron.
2. Place lock washer on axle bolt. Then tighten nut securely
to threaded part of axle bolt.
3. Repeat procedure with other side.
Nut
Figure 4 - Wheel Assembly

Operation

BEFORE FIRST START-UP
BREAK-IN PROCEDURE
Note: This is an oilless compressor. Do not add oil.
(Complete this procedure before using compressor for the first
time. Once completed, it is not necessary to repeat.)
1. Open drain valve located on bottom of tank.
2. Turn ON / OFF switch to OFF position.
3. Plug in power cord.
4. Turn ON / OFF switch to ON position and run compressor
for 30 minutes.
5. Turn ON / OFF switch to OFF position.
6. Unplug power cord.
7. Close drain valve.
The compressor is now ready for use.
OPERATING PROCEDURE
1. Turn switch to OFF position and plug in power cord.
2. Turn regulator knob counterclockwise to close air flow.
3. Turn switch to AUTO position.
4. Compressor will build to maximum pressure and shut off.
5. With hose attached to outlet of compressor, attach tire
chuck or other tool to open end of hose.
6
Washer
Wheel
Axle Bolt