Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps - Accessory Panel
8
Using provided 12mm hardware, bolt the Off-
Road Jack Mount to the Accessory Panel as
shown.
9
Adjust Jack Mount so the base is level to the
ground and tighten all hardware.
10 Off-Road Jack Installation
Carefully place Off-Road Jack on Mount Base.
Insert the provided Vertical Support Stud
through the Upper attachment point and
through the corresponding hole in the Jack.
Make sure the flat edged of the Stud and
recessed into the Jack Mount.
Using the provided internally threaded knob,
snug the Jack to the mount.
Do not tighten completely.
11
Insert the provided T-Block into the base of the
Jack as shown.
Thread the threaded knob from the bottom of
the Jack Mount, up into the T-Block.
Do not tighten completely.
NOTE: Actual application may vary slightly from illustrations.
Page 4 of 6
Publicidad
Tabla de contenido
