Wheel Assembly - Speedaire 1NNF4 Instrucciones De Operación

Speedaire Operating Instructions
Speedaire
Compressors
Assembly
E
REGuLATOR
N
1. Remove plug(s) from plastic bag.
G
Apply thread sealant tape to
L
threads.
I
2. The assembly is designed to be
S
attached only to the pressure switch
H
outlet (see Figure 1) by inserting
the pipe nipple (see Figure 2) and
turning the assembly clockwise.
Tighten until snug or 75 in.-lb.
Gauge should be oriented the
same as the gauge already on
the pressure switch (see Figure 1).
Attach hose and tire chuck. Check
for leaks with soapy water.
Gauge
Apply
Thread
Sealant
Here
Regulator
Figure 2
HORIzONTAL TANk uNITS ONLy
HANDLE
1. Remove the handle screw from the
tank baseplate, if preinstalled.
2. Insert handle into both sides of tank
baseplate. Squeeze handle to fit
into special openings in baseplate
(See Figure 3).
Portable Air
®
Handle
Foot *
Figure 3
3. Place a short piece of wood against
end of handle and tap with a mallet
or hammer until the hole in the
Pressure handle lines up with the hole in the
Switch
baseplate.
4. Insert and tighten the handle screw
into the hole in the baseplate and
through the handle. Make sure the
O
screw goes through the handle.

WHEEL ASSEMBLY

The items marked with an asterisk (*)
in Figure 4 were shipped loose with the
1/4 inch
unit. Assemble as follows:
Pipe Nipple
1. Insert shoulder bolt through wheel
hub with the bolt head on the
opposite side of the protruding hub
section.
Lock
Nut *
Figure 4
Tank
Baseplate
Nut *
Handle
Screw
Bracket
Bolt *
Wheel *
Shoulder
Bolt
4
2. For the 8 inch diameter wheels,
insert the shoulder bolt in the low-
est hole of the tank axle iron and
tightly secure with locknut.
3. For the 10 inch diameter wheels,
insert the shoulder bolt in the upper
hole in the tank axle iron and tightly
secure with the locknut. Repeat this
step on the opposite side.
When assembled, the tank must sit level
or slope slightly towards the tank drain
valve to allow tank to drain properly.
vERTICAL TANk uNITS ONLy
HANDLE ASSEMBLY
Insert handle through brackets on tank
(See Figure 5).
Handle
Figure 5
FOOT ASSEMBLY
The items marked with an asterisk (*)
were shipped loose with the unit (See
Figure 6).
1. Tilt unit to allow access to front foot
and secure properly to ensure unit
does not tip over.
2. Insert bolt through foot and
bracket. The foot should be on the
lower side of bracket.
Tank
Baseplate