MIRKA Deros Instrucciones De Manejo página 61

How to get started
When unpacking the tool, make sure it is intact, complete and has not been damaged in transport Never use a
damaged tool
Before use, check that the backing pad is correctly attached and tightened Connect the power cord to the sander
Connect the power cord to a grounded outlet (220–240 VAC, 50/60 Hz)
In order to get the maximum power from this tool it is recommended to use it with the Mirka dust extractor (or
other suitable dust extraction unit) and Mirka Net Sanding products The combination of Mirka sanders, net sanding
products and Mirka dust extractor are the basis of Mirka dust-free sanding solutions
The power cord from the sander is connected to the mains supply on the front of the dust extractor By connecting
the sander's power cord to the outlet on the dust extractor it is possible to use the dust extractor's autostart function
Operating instructions
• The tool is intended to be operated as a hand held tool The tool can be used in any position Note! The sander can
develop a torque reaction when started
• Make sure the sander is switched off Select a suitable abrasive and secure it to the backing pad Make sure the
abrasive is centred on the backing pad For optimal performance we recommend a Mirka backing pad and Mirka Net
Sanding product
• Switch on the sander by pressing the On/Off key, Figure 1 The sander LED (right) is now green
• The sander can now be started by pressing the lever
• The speed can be adjusted between 4,000 and max rpm by adjusting the position of the lever
• The max rpm can be adjusted by pressing rpm+ or rpm–, Figure 1 Each press increases or reduces the speed by
1,000 rpm until it reaches the limits The rpm can be adjusted in the range 4,000 to 10,000 rpm
• The tool has two speed control modes In the default mode the speed can be adjusted linearly by changing the
position of the lever In the other mode the speed remains fixed at the set max rpm when the tool is running When
the rpm+ and rpm– buttons are pressed simultaneously the tool toggles between the two controlling modes
• When sanding, always place the tool on the work surface before starting the tool Always remove the tool from the
work surface before stopping it This will prevent gouging of the work surface due to excess speed of the abrasive
• When sanding is finished, turn off the sander by pressing the On/Off key The sander LED (right) is now turned off
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an App from which additional
tool functionality can be accessed For more information on the App functionality and if it is available in your country,
go to www mirka com
Activate Bluetooth on your Mirka® DEROS as follows:
1 Connect the power cord to mains outlet
2 Press and hold the rpm+ button while switching the tool on with the On/Off button
3 Left LED lights up (green), to indicate that Bluetooth is active
4 Bluetooth is deactivated when the tool is disconnected form mains outlet
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc and any use of such
marks by Mirka Ltd is under license Other trademarks and trade names are those of their respective owners
Mirka® DEROS • 77 mm (3"), 125 mm (5") & 150 mm (6") • 230 V
en
61