Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Step 4: Attach fixture and coverplate to the junction box and fasten
securely with screws, making sure no wires are sticking out from
underneath the coverplate.
Step 5: Apply silicone caulk around the edges of the coverplate to
provide a watertight seal from rain and moisture.
Step 6: Turn on power at main fuse/breaker box. NOTE: This fixture
can be used with a dimmer switch to adjust light output.
To install a dimmer switch: Use a dimmer switch designed for
incandescent lighting that has a rating of 300 watts or higher.
Follow the installation instructions included with the dimmer
switch. Keeping the halogen bulb in a dim mode for an
extended period of time may shorten the life of the bulb. To
achieve maximum bulb life, occasionally turn the switch to
full brightness for a few hours.
Aiming your fixture
NOTE:The bulb and fixture get extremely hot during use.
For optimum performance halogen fixtures must be mounted so that the
bulb is within 4 degrees of horizontal. Adjust fixture vertically to desired
position and tighten swivel bolt securely. Refer to the back of the fixture
for mounting arrow showing correct upright installation position.
Servicing your fixture
CAUTION:When replacing bulb in the fixture, always replace with the
same wattage bulb or a lower wattage bulb. DO NOT replace with a bulb
of greater wattage than specified on the fixture. To do so could
create a fire hazard and or shorten the life of the bulb.
NOTE: If lens is replaced, use only tempered safety glass of equal
thickness.
What to do if . .
LIGHTS DO NOT
Is there power to the fixture?
COME ON
• Has the house circuit breaker tri p p e d ?
• Is the wall switch on?
Is the bulb firmly seated? Is the bulb good?
TURN OFF POWER BEFORE CHECKING.
Is the wire to the unit loose?
Five year limited warranty
Cooper Lighting ("the Company") warrants this product ("the product")
against defects in material or workmanship for a period of five years from
date of original purchase, and agrees to repair or, at the Company's
option, replace a defective product without charge for either replacement
parts or labor during such time. This does not include labor to remove or
install fixtures.
4
(continued)
Publicidad
