Malfunctions; Changing Over Door Hinges - J.P. SELECTA TUV NORD TEMPLOW-M Manual Del Usuario

INSTRUCTION MANUAL CODE 80177 REV A
J
.P. SELECTA s.a.u.
July/2009

16. MALFUNCTIONS

In case of malfunction, you may be able to check the following:
* The appliance does not function, the control lamps do not lit:
- Is the appliance switched on?
- Is the plug correctly fitted in the mains socket?
- Is the fuse burned out?
* The temperature is not low enough:
- Is the temperature setting correct?
- Have excessive amounts of material been placed in the appliance?
Check the displayed temperature after 24 hours.
- Is the ventilation system working properly?
- Is the appliance set up too close to a heat source?
If none of the above causes apply and you cannot rectify the fault yourself, please
contact the technical service.

17.CHANGING OVER DOOR HINGES

- Close the door and unscrew the lower hinge bracket (1).
- Lift the door, tilt it to the right and remove it.
- Rotate 180º and remove the lower hinge spin (2) and screw it on the opposite side.
- Unscrew upper hinge elements (3) and screw them on the opposite side.
- Attach the hinge (4) and the plugs (5) to the opposite side.
- Transfer lower hinge bracket and cover plate (6) to the opposite side.
- Locate door on upper pin.
- Tilt door inwards from the left and secure the hinge pin with a screw.
- Transfer handle and plugs to the opposite side of the door.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: www.jpselecta.es
(They can be modified without notice)
Tel 34 937 700 877 Fax 34 937 702 362
Page: 15